Primer / Filler application - metal - Non VOC

non VOC 35
TST 59 (1).png

1. Masking

  • Mask the repair area
  • make sure to mask with soft edges, hard edges will leave marks in basecoat
  • Clean with 70-10
TST 59 (5).png

2. Primer application

  • For corrosion protection on large bare metal, 27-10 is recommended
TST 59 (9).png

3. Mixing ratio:

  • 27-10 Washprimer 100%
  • 57-10 Hardener 50%
  • 60- Reducer 30%

Application: 

  • 1 coat (see 27-10 TDS)

Flash off: 

  • 10 min at 20°C
TST 59 (10).png

4. Filler process

  • Prepare undercoat according to the car color 20-24
  • To obtain different grey shades, fillers can be mixed
TST 59 (4).png

5. Mixing ratio:

TST 59 (6).png

6. Application of filler:

  • Spray 2 coats on repair to obtain 50 to 70 microns
  • Flash of 5 min between both layers
  • Stay with second coat in the pattern of the first coat

Dry Properties:

  • 8 min short wave
  • or 3 hours at 20°C
  • or 30 min at 60°C
TST 59 (2).png

7. Sanding guide

  • Use of sanding guide, highlight surface imperfections and possible sand scratches prior to finish with abrasives
TST 59 (7).png

8. Sanding steps

  • Hand block with P320 / P400 for perfect levelling prior to machine sanding
TST 59 (8).png

9. Sanding steps

  • Fine sand area with 3mm orbit machine and P 320
  • finish with P 400/ P 500
  • Blend in area P1000/2000
TST 59 (3).png

10. Cleaning

  • Clean carefully with 70-10
  • Use wipe on, wipe off method (2 cloths)
Repair Steps

Start working with baslac today. It just makes sense.

Contact us

Get in touch with your local baslac dealer now and start working smarter.

Find a dealer near you