Primer / Filler application - metal - 45 LVOC

• Mask the repair area
• Make sure to mask with soft edges, hard edges will leave marks in basecoat
• Clean with 70U-10

• For corrosion protection on large bare metal, 23U-10 is recommended

   

Application: 

• 2-3 coats (see 23U-10 TDS)

   

Flash off: 

• 15-20 min at 68°F (20°C)

• Prepare undercoat according to the car color 20U-23 / -24 / -25
• To obtain different grey shades, fillers can be mixed

• 20U-23/-23/-23                     4                         
• 50U-15/-20/-30                   1
• 60U-10/-20/-30/-40           1

• Spray 1-2 coats on repair to obtain 2.0-3.0 mil.
• Flash off for 5 min at 68°F (20°C) between coats.
• Keep the application of the second coat within the pattern of the first coat.

Dry Properties:

• 5-7 min short wave
• 1-1.5 hours at 68°F (20°C)
• 30-40 min at 140°F (60°C), allow 10 min flash before baking

• Use of sanding guide, highlight surface imperfections and possible sand scratches prior to finish with abrasives

• Hand block with P320 / P400 for perfect levelling prior to machine sanding

•  Fine sand area with 3mm orbit machine and P 320
• Finish with P 400/ P 500
• Blend in area P1000/2000

• Clean carefully with 70U-10
• Use wipe on, wipe off method (2 cloths)