Primer / Filler application - metal - 45 LVOC

45 LVOC
TST 59 (1).png

1. Masking

  • Mask the repair area
  • Make sure to mask with soft edges, hard edges will leave marks in basecoat
  • Clean with 70U-10
23U-10 Aerosol

2. Aerosol application

TST 59 (5).png

2. Primer application

  • For corrosion protection on large bare metal, 23U-10 is recommended

     

Application: 

  • 2-3 coats (see 23U-10 TDS)

     

Flash off: 

  • 15-20 min at 68°F (20°C)
product_preparation_20U

4. Filler process

  • Prepare undercoat according to the car color 20U-23 / -24 / -25
  • To obtain different grey shades, fillers can be mixed
mixing-ratio-20U-50U-60U

5. Mixing ratio:

  • 20U-23/-23/-23                     4                         
  • 50U-15/-20/-30                   1
  • 60U-10/-20/-30/-40           1
TST 59 (6).png

6. Application of filler:

  • Spray 1-2 coats on repair to obtain 2.0-3.0 mil.
  • Flash off for 5 min at 68°F (20°C) between coats.
  • Keep the application of the second coat within the pattern of the first coat.

Dry Properties:

  • 5-7 min short wave
  • 1-1.5 hours at 68°F (20°C)
  • 30-40 min at 140°F (60°C), allow 10 min flash before baking
TST 59 (2).png

7. Sanding guide

  • Use of sanding guide, highlight surface imperfections and possible sand scratches prior to finish with abrasives
TST 59 (7).png

8. Sanding steps

  • Hand block with P320 / P400 for perfect levelling prior to machine sanding
TST 59 (8).png

9. Sanding steps

  •  Fine sand area with 3mm orbit machine and P 320
  • Finish with P 400/ P 500
  • Blend in area P1000/2000
TST 59 (3).png

10. Cleaning

  • Clean carefully with 70U-10
  • Use wipe on, wipe off method (2 cloths)
Repair Steps

Comience a trabajar con baslac hoy mismo. Simplemente tiene sentido.

Contáctenos

Póngase en contacto con su distribuidor local de baslac ahora y comience a trabajar de manera más inteligente.

Encuentre un distribuidor cerca de usted